Why have 2 settings? Couldn't you just read the bright/dim status from the empeg based on if the headlights are on/off.

Basically, when you first set your LED level in hijack (either headlights on or off), have it set both dim/bright settings, then if I toggled my headlights, the LED level would be exactly the same, unless I went into hijack again while the headlights are on, and re-adjusted the LED brightness levels. Then because the headlights are on, it would update the bright setting.

I wouldn't leave the “+ 1 / 2” code in the picture at all, because this way we could have full control over both headlight modes

bright would = headlights +12v
dim would = headlights -0v

I guess I’m asking for the exactly functionality as the default empeg screen brightness control, I guess if it is also possible, it would be neat to also be able to tie into the default brightness slider and have it also control the LED brightness levels, but that would have to also be switched on and off in hijack someplace, or at least in the config file.

Anyways, this is just my 2 cents, I’ll stop wishing now ;-)